MAINTENANCE 2. Be sure the cooling system and coolant are cold, do not run the engine to warm the coolant. Remark Always drain the coolant when the engine and coolant is cold. 3. Remove radiator cap (2), turn it until it contacts the stopper, then remove it. 4. Remove the cover (3), then set the container under drain valve (4) to catch the coolant mixture. 5. Open drain valve (4) at the bottom of the radiator and drain the coolant. 6. After draining the antifreeze solution, close drain valve (4), then fill with clean water. After the radiator is filled with water, start and run the engine at low idle speed.
After the water temperature rises above 90 o C (194 o F), run the engine for about 10 minutes. 7. Stop the engine and allow the engine to cool down completely. Open drain valve (4) to drain the water. 8. After draining the water, flush the cooling system again. For the cleaning, use only approved Komatsu Cooling System Flush, (Restore and Restore Plus by Fleet Guard) follow the instruction on the flushing solution. 9. Close drain valve (4). 10. Install the cover (3). 11. Replace the corrosion resistor, then turn the valve (1) fully to the left to open it. (Only machines equipped with corrosion resistor) 12. Add coolant mixed with antifreeze until it overflows from the water filler.
Decide the proportions of antifreeze and water according to the table for the mixing rate of water and antifreeze. Run the engine at low idling for 5 minutes to remove the air from the water, then run at high idling for 5 minutes.(Leave radiator cap (2) removed when doing this.) 13. Drain the coolant from sub-tank (5), clean the inside of the sub-tank, then add water until the coolant level is between the FULL and LOW marks. 14. Stop the engine, wait for approx. 3 minutes, then add coolant until the coolant level is near the coolant filler port, and tighten the cap. Check the coolant level and add coolant if necessary. PC300LC/HD-7E0 3-27