5. The monitor display screen switches to the selection screen shown on the right. OPERATION Press return switch (8) The monitor display screen returns to the standard screen. SETTING OIL FLOW 1. Press selector switch (7). 2. The monitor display screen switches to the selection screen shown on the right. Use UP switch (9) and DOWN switch (10) to select the oil flow setting (B), then press Enter switch (11) to accept the change. (The selected monitor is highlighted in black.) Remark Oil flow setting (B) can be selected only on machines with an attachment installed. When working mode is P mode or E mode 1. The monitor display screen switches to the oil flow setting screen shown on the right.
Use UP switch (9) and DOWN switch (10) to select the desired oil flow. One segment is approximately 70 liter (18.49 US gal)/min. Full oil flow: approximately 535 liter (141.35 US gal)/min. 2. After selecting the oil flow, press Enter switch (11) to accept the change. 3. The monitor display screen switches to the selection screen shown on the right. Press return switch (8) The monitor display screen returns to the standard screen. Remark Even when the ignition switch is turned OFF, the oil flow set by the above operation remains as the set value when the engine is started next. PC300LC/HD-7E0 2-29