EPA07 MBE 4000 OPERATOR'S MANUAL priming pump for two to three minutes or until resistance is felt. NOTICE: To prevent damage to engine components, keep the water moving at all times while cleaning. Never direct water onto electrical components, plug connectors, seals or flexible hoses. 2. If the engine is equipped with only a priming port located on the fuel filter module, have an authorized repair facility prime the fuel system. 3. Crank the engine for 30 seconds at a time, but no longer. Before cranking the engine again, wait at least two minutes. The engine should start within four 30 second attempts. 4.
If the engine fails to start, ensure the vehicle has adequate fuel and the fuel system is not leaking externally. To avoid injury, wear a face shield or goggles. Comply with the minimum working distance between the high-pressure nozzle and the surface being cleaned: 5. If problem persists, call an authorized repair facility. Approximately 700 mm (28 inches) for circular pattern jets How to Clean the Engine Important: Observe all environmental protection regulations.
Approximately 300 mm (12 inches) for 25-degree flat jets and dirt cutters High-Pressure Cleaning Equipment How to Clean the Cooling System Information on suitable cleaning and protective products is available from any authorized dealer. Note the equipment manufacturer's operating instructions. Important: Collect the used coolant, cleaning solutions, and washing liquids and dispose of them in an environmentally responsible manner. Clean as follows: All information subject to change without notice. 97 DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION