MAN — Man EPA07 MBE 4000 Engine Operator's Manual

HOW-TO SECTION Degreasing Clean at moderate pressures only; otherwise the fins of the radiator grille could be damaged. NOTICE: Degrease as follows: 1. Fill the cooling system with a 5% solution (1.6 ounces per quart of water — 50 grams per liter) of a mildly alkaline cleaning agent, such as sodium carbonate. 1. First remove debris (dust, insects, etc.) from the fins of the radiator grille. 2. Run the engine at moderate speed until the thermostat starts to open, at an operating temperature of approximately 80°C (176°F). Then run it for about five minutes longer. Shut down the engine and allow it to cool to approximately 50°C (112°F).

EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Remove the debris by blowing them through with compressed air or spraying them out with water. Work from the rear of the radiator (in the opposite direction of the normal cooling air flow). 3. Drain the coolant when the engine is cold. For detailed procedures, see the vehicle/chassis maintenance manual. For types of coolant, Refer to the”How to Select Coolant" section. 4. If the HVAC unit is connected to the cooling system, open the regulating valves all the way.

98 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION