MAN — Man EPA07 MBE 4000 Engine Operator's Manual

EPA07 MBE 4000 OPERATOR'S MANUAL “How to Select Coolant” section in this guide. HOT COOLANT How to Select Coolant To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. This section covers selection of the required coolant for MBE 4000 engines. Definitions To help ensure complete understanding of the information, the definitions of the following terms are provided: 3. Drain all the cleaning solution.

Antifreeze — Ethylene Glycol (EG) or Propylene Glycol (PG) containing a corrosion inhibitor package and meeting an appropriate heavy-duty specification, i.e., TMC RP-329 “Type A” EG, TMC RP 330 “Type A” PG or TMC RP organic acid ethylene glycol. 4. Flush the cleaning solution from the cooling system. [a] Immediately after draining the cleaning solution, flush the system with clean water. [b] Once the clean water has drained, fill the system again with clean water. NOTE: TMC RP-329 and TMC RP-330 “Type A” formulations are phosphate free. [c] Run the engine. Allow the engine to warm up to approximately 80°C (176°F), and then run it about five minutes longer.

Coolant The fluid mixture circulating in the engine cooling system, typically a mixture of 50% water and 50% antifreeze. [d] Drain the hot water. Drop–Out — Precipitated sludge or deposit formation in or on cooling system components. 5. Fill the cooling system with new coolant. For detailed procedures, see the vehicle/chassis maintenance manual. For types of coolant, refer to the All information subject to change without notice. 99 DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION