MAN — Man EPA07 MBE 4000 Engine Operator's Manual

HOW-TO SECTION NOTE: Fully formulated antifreeze does not require a dosage of SCA prior to initial use. Mixing EG or PG Antifreeze and Water If a concentrated Ethylene Glycol (EG) or Propylene Glycol (PG) antifreeze is purchased, mix the antifreeze with water meeting the required quality standards and fill the cooling system. For water requirements , If a concentrated EG or PG antifreeze is purchased, mix the antifreeze with water meeting the required quality standards and fill the cooling system. For water requirements , refer to section Water Requirements. If a pre-diluted, fully formulated coolant is purchased, simply fill the cooling system.

For best overall performance, a coolant consisting of 50% concentration of antifreeze (50% antifreeze, 50% water) is recommended . An antifreeze concentration of over 67% (67% antifreeze, 33% water) is not recommended due to poor heat transfer, reduced freeze protection (IEG only), and possible silicate dropout. An antifreeze concentration below 33% (33% antifreeze, 67% water) offers too little freeze and/or corrosion protection and is not recommended . 102 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION