MAN — Man EPA07 MBE 4000 Engine Operator's Manual

OPERATING INSTRUCTIONS FOR STARTING THE ENGINE Authorized Detroit Diesel service outlets are properly equipped and have the trained technicians to perform this service. separator, work the hand pump until resistance is felt. NOTE: There should be a strong resistance in the hand pump, caused by the pressure buildup within the fuel system. Priming is not normally required if the filter elements are filled with clean fuel when installed and the lines are not drained of fuel. If the engine is equipped with a fuel/water separator, drain off any water that has accumulated. Water in fuel can seriously affect engine performance and may cause engine damage.

Detroit Diesel recommends installation of a fuel/water separator wherever water contamination is a concern. 2. Crank the engine for 30 seconds at a time, but no longer. Wait at least two minutes. The engine should start within four 30-second attempts. Other Checks Make sure the transmission is filled to the proper level with the fluid recommended by the gear manufacturer. Do not overfill. Adding Fuel When adding fuel, pay attention to the following: Add winter or summer grade fuel according to the season of the year. Work in the cleanest conditions possible. Prevent water from entering the fuel tank. For further information, Refer to the “HOW-TO SECTION” of this guide.

Priming the Fuel System Prime the fuel system as follows: 1. If equipped with a hand pump on the fuel filter or fuel/water 22 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION