USE OF THE MACHINE gears, make sure that the equipment is lifted at about 30 cm from the ground. Before moving the machine, make sure that there is no one within the operating radius of the machine and that there are no obstacles in the surrounding area. Be extremely careful when engaging the reverse and make sure that there are no persons, working means or obsta- cles in the way. Before moving the machine, check the instruments, warm up the engine and the hydraulic oil and then make sure that the stabiliz- ers are completely raised. At this point, release the parking brake. RKAA0951 The gears must be engaged with the engine at low rpm, in order to avoid an abrupt acceleration.
For the operation of the gearshift and its functions, see «3.2.5 MACHINE CONTROLS»). The gearshift is completely synchronized, therefore it is not necessary to decelerate to shift gears when the ma- chine has to keep travelling in the same direction. If it is necessary to shift down, first reduce the engine rpm and then shift down. If it is necessary to reverse, slow down by putting on the brakes before operating the reverse lever. 134 3.6.5 HOW TO MOVE THE MACHINE DANGER • Before moving the machine, make sure that you know the control functions and all the relevant safety regulations perfectly.
• The operator must be sitting in the driving position with fastened safety belt and must have checked the position of the rear-view mirrors. • Before selecting the travel direction and engaging the 3 0 c m RKA01090 DANGER Proceed as follows: 1 - Select the operating mode (TRAVEL or TRAVEL-WORK). 2 - Select the steering mode (see «3.2.5 MACHINE CON- TROLS»). 3 - Select the travel direction, by shifting the control lever for- ward (F) or backward (R). 4 - Engage the gears within 5 seconds from the selection of the travel direction. 5 - Accelerate gradually using the accelerator pedal. F N FR IMPORTANT RKAA1270