Komatsu — 4.7.3.d LUBRICATING BOOM

MAINTENANCE PLAN 4.7.3.d LUBRICATING BOOM with stabilizers, lower them to the ground, otherwise place a block in central position under the frame. 2 - Slowly extend the boom sections until they are completely out and in horizontal position; stop the engine and apply the parking brake. 4 3 - Remove any used oil from the boom sections and clean the block sliding areas and the grease nipples (1) and (2) thor- oughly. 4 - Using the grease nipples (1) and (2) positioned on the lower end of the main (3) and intermediate (4) boom sections, in- ject grease to lubricate the front sliding pads.

1 2 RKAA2000 5 - Using a brush ( A ) or a roller, spread grease of the recom- mended type on sliding surfaces (see «4.3 FUEL, COOLANT AND LUBRICANTS»). 6- Start the engine and extend and retract the boom sections completely several times, in order to distribute the grease evenly on the pads. A 7- With the boom sections completely retracted, stop the en- gine. RKAA1960 8 - Lubricate the upper pads of the intermediate and final boom sections with the grease nipples (5) and (6). * , , * 203 DANGER • The boom sections must be lubricated when they are com- pletely extended.

As a safety precaution, position a stand capable of supporting the entire boom under the first tele- scopic boom before extending the boom sections and low- er the stabilizers to the ground, if they are provided. • If the machine isn’t equipped with stabilizers, place a safety block in central position under the front part of the frame. 1 - Position the machine on firm and level ground and select the TRAVEL-WORK operating mode; if the machine is equipped 2 1 3 RKAA1950 DANGER