MAINTENANCE PLAN 4.7.4.b LUBRICATING THE FRONT AND REAR AXLE SWING JOINT The four lubrication points (1) of the swing axle are located on its support flanges (2). The joint must be lubricated after thoroughly cleaning the grease nipples, by applying the greasing pump filled with the prescribed grease (see «4.3 FUEL, COOLANT AND LUBRICANTS»). Once the lubrication procedure has been carried out, remove the used grease that may have spread out of the joints. 2 1 RKAA2200 2 1 RKAA2210 4.7.4.c LUBRICATING THE WHEEL HUB JOINTS The lubrication points of the hub joints are shown in the figure and it is important to remember that they are located in symmetrical positions on the machine.
The joints must be lubricated after removing the guards and after thoroughly cleaning the grease nipples (1) and (2), by applying the greasing pump filled with the prescribed grease. (See «4.3 FUEL, COOLANT AND LUBRICANTS»). Once the lubrication procedure has been carried out, remove the used grease that may have spread out of the joints and put back the guards. 1 2 RKAA1620 205