MAINTENANCE PLAN 4.7.5 MAINTENANCE AFTER THE FIRST 250 HOURS OF OPERATION These maintenance operations should be carried out after the first 250 hours of operation, together with those to be performed every 250 HOURS. a - CHANGE THE HYDRAULIC OIL DRAIN FILTER b - CHANGE THE AXLE OILS (DIFFERENTIAL AND FINAL REDUCTION GEAR UNITS) c - CHANGE THE TRANSMISSION FILTER NOTE For details on operations not mentioned in this paragraph, see «4.7.8 MAINTENANCE EVERY 500 HOURS OF OPERATION OR EVERY 6 MONTHS» and «4.7.9 MAINTENANCE EVERY 1000 HOURS OF OP- ERATION OR EVERY YEAR».
4.7.6 MAINTENANCE EVERY 250 HOURS OF OPERATION OR EVERY 3 MONTHS These maintenance operations should be carried out together with those to be performed every 10 HOURS and every 50 HOURS. 4.7.6.a LUBRICATING THE ARTICULATED JOINTS If the machine is used in difficult conditions, carry out these operations more frequently than usual. 1 - Park the machine on firm and level ground, as described in «3.7.1 PARKING ON LEVEL GROUND». 2 - Make sure that the gearshift-reverse lever (1) is in neutral po- sition (N) and apply the parking brake (2). 2 3 - Stop the engine, proceeding as described in «3.8 STOPPING THE ENGINE». 4 - Remove the ignition key.
The ignition key must be kept by the person in charge of maintenance until the end of work. 5 - Lubricate using a syringe filled with the prescribed grease. (See «4.3 FUEL, COOLANT AND LUBRICANTS» and the maintenance chart). RKAA0873 206 DANGER • The compensating cylinder must be lubricated on the base side from an intermediate position between the frame and the wheel; always apply the parking brakes and remove the ignition key. 1 (N) IMPORTANT • Clean the grease nipples thoroughly before applying the greasing pump. • After lubrication, remove all the contaminated grease that may have spread out and clean the area. RKAA1274 DANGER