MAINTENANCE PLAN 4.7.6.c CHECKING THE AXLE OIL LEVEL (FRONT AND REAR AXLE) DIFFERENTIAL This is a visual check and serves to verify if the lubricant reaches the hole (1); if necessary, top up using the prescribed oil. (See «4.3 FUEL, COOLANT AND LUBRICANTS»). The level hole (1) must be used also as filling hole. Use a 12 mm wrench. 1 RKAA1540 1 RKAA1550 FINAL REDUCTION GEAR This check must be carried out on each reduction gear positioned with its plug on the horizontal axis. If necessary, move the machine slightly until reaching the speci- fied position, which is indispensable for an accurate check.
This a visual check and serves to verify if the lubricant reaches the hole (2); if necessary, top up using the prescribed oil. (See «4.3 FUEL, COOLANT AND LUBRICANTS»). Use a 12 mm wrench. 2 RKAA1560 208