Komatsu — 4.7.6.d CHECKING THE TRANSMISSION OIL LEVEL

MAINTENANCE PLAN 4.7.6.d CHECKING THE TRANSMISSION OIL LEVEL The transmission oil level must be checked with engine running and transmission still hot; be extremely careful and wear insulating, waterproof gloves in order to avoid severe burns. 1 - Before carrying out this check, park the machine on level ground; clean the area to be inspected (dipstick, filler cap and reduction gear sight gauge) thoroughly. Heat the trans- mission oil until it reaches 85–88 °C and keep the engine idling. 1 RKAA1570 2 - Open the engine hood and extract the dipstick (1). 3 - Make sure that the level reaches the maximum mark.

If necessary, with the engine still idling, add the appropriate quantity of the prescribed oil. (See «4.3 FUEL, COOLANT AND LUBRICANTS»). 2 4 - Reintroduce the dipstick and stop the engine. 5 - Make sure that the reduction gear oil level is halfway up the sight gauge (2). If necessary, remove the filler cap (3) and top up with the pre- scribed type of oil. (See «4.3 FUEL, COOLANT AND LUBRI- CANTS»). 6 - Put back the filler cap and wipe up any oil that may have been spilled during the procedure. RKAA2021 3 RKAA2111 209 DANGER