MAINTENANCE PLAN If the above condition is not fulfilled, proceed as follows: a - loosen the lock nut (10) of the retraction chain adjust- ing nut (11); b - loosen the adjusting nut (11) (by turning it anticlock- wise); c - extend the boom sections approximately 500 mm and then retract them; d - make sure that the intermediate boom section (8) makes contact with the main boom section (9) (A = 0mm); 10 RKAA1660 to carry out the third one, have your Komatsu Utility Dealer check the stretching of the chain. NOTE If the nut reaches the end of the thread, contact your Ko- matsu Utility Dealer to have the chain replaced. 7 - Tighten the lock nut (10) and lock it.
223 ATTENTION e - if necessary, repeat the adjustment procedure until the precise distance/contact is obtained. 4 - Measure the distance “B” when the intermediate boom sec- tion is in contact with the main boom section. 5 - Extend the boom sections approximately 500 mm. 6 - Tighten the chain adjusting nut (11) (turning it clockwise) until the distance between the end boom section being retracted and the intermediate section corresponds to “B”. 11 IMPORTANT 10 • After two adjustments have been made, before attempting RKAA1670