Komatsu — 4.7.8.i CHECKING AND TIGHTENING THE BOOM CHAINS (Only for the 3-section boom version)

MAINTENANCE PLAN BOOM EXTENSION CHAINS The distances “H” of the two chains (12) must be equal to each other, and the measure of said distance “H” must be in the range of 0–1 mm. ' ' ' "!;& ""9 &:2"" 7 7 %!!8 %"; ' * ""9 &:2"" 224 After adjusting the retraction chain, adjust the extension chains using the rear adjustment unit “D” and proceed as follows: 1 - Extend the boom completely and place a stand under the in- termediate section in order to prevent the boom from falling down. ATTENTION   • The stand must have a minimum carrying capacity of 10 tons and must be positioned under the intermediate boom section. Do not rest the boom so as to it can run freely.

  ATTENTION 2 - Slowly retract the boom sections approximately 50 mm to slacken the chains (12) slightly. 3 - Measure the distance “H” between the chains (12) and the surface of the boom (7) halfway between the front sprocket and the rear coupling, that is in the rear casing connection ar- ea. 12 ATTENTION H • H” is a fixed value for this machine and corresponds to: WH613-1 WH713-1 WH714-1 WH714H-1 WH716-1 7 RKAA1680 14 mm 12 mm 8 mm 7 RKAA1680 ATTENTION WH613-1 WH713-1 WH714-1 WH714H-1 WH716-1 14 mm 12 mm 8 mm