MAINTENANCE PLAN 14 14 RKAA1700 15 15 16 16 RKAA1710 tact your Komatsu Utility Dealer to have the chains re- placed. 225 4 - If the distance “H” doesn’t correspond to the fixed value set for the machine, remove the split pins (13), loosen the lock nuts (14) and screw the tightening nuts (15) without moving the tie rods (16). 13 13 IMPORTANT • Screw the tightening nuts alternately, taking care to pre- vent the tie rods (16) and the chains from rotating. • Replace the split pins (13). 7 - Once the set tension value has been reached, tighten the lock nuts (14).
RKAA1690 NOTE • After two adjustments have been made, before attempting to carry out the third one, have your Komatsu Utility Dealer check the stretching of the chains and evaluate if it is nec- essary to change them. • The maximum chain stretching allowed corresponds to 3%. For this check, count 33 pitches of the mounted chain; at this point, measure this last distance and if it is equal to or exceeds 647.7 +03.5 mm (= 34 pitches of a new chain) it is necessary to change the chain. Contact your Komatsu Util- ity Dealer to have the chains replaced. RKAA1720