PRECAUTIONS TO BE TAKEN DURING WORK Do not move or handle the load over people working in the manoeuvre area or passing through it. Pay the utmost attention to overhead lines, systems, lights, etc. 1 - Move slowly, in perpendicular direction, trying to get as near the unloading area as possible; apply the parking brake and put the machine in neutral. 2 - If necessary, level the frame. If the machine is equipped with stabilizers, lower them until raising the wheels from the ground keeping the frame level. 3- Select the TRAVEL operating mode (see «3.2.5 MACHINE CONTROLS» pos. 3 - OPERATING MODE SELECTION UNIT).
4 - Lift and extend the boom to the point where the load must be deposited, making sure not to exceed the maximum angle and extension allowed by the load chart corresponding to the operating conditions (on wheels or stabilizers) and to the equipment installed. RKA01301 If the maximum extension and angle allowed are exceeded, the machine isn’t stable and this condition will be signalled by the acoustic alarm. If the stability limit indicated and signalled by the SLI-Safe Load Indicator is reached, the machine can- not get nearer the unloading area and the operation must be interrupted, since the load exceeds the ca- pacity of the machine.
4 - Incline the load forward until it is in horizontal position, in any case slightly raised from the place where it must be unloaded. 5 - Lower the boom until the load rests on the chosen support and, after making sure that it is stable, carry out combined boom lifting and retracting manoeuvres until releasing the fork or the equipment completely. To release the load, carry out only and exclusively the manoeuvres described above. Do not release the load using the reverse gear. Before moving the machine: a - retract the boom and lower it to the travel position; b - raise the stabilizers completely. 49 DANGER DANGER ATTENTION