PRECAUTIONS TO BE TAKEN DURING WORK 2.4.10 PREVENTING ELECTROCUTION Digging operations near overhead electric lines are extremely dangerous and they may also cause death due to electrocution; for this reason, when working near overhead electrical lines always respect the minimum safety distances prescribed by the competent authorities and by the accident-prevention rules in force. As far as underground long-distance lines are concerned, the minimum distance depends on the covering of the ducts in which the cables are laid. The basic safety precautions to be taken to prevent this risk are the following: 1 - Wear shoes with thick rubber or leather soles.
2 - Request the aid of another person who can warn you if the machine gets too close to the electric line. 3 - Operate at low speed. 4 - Learn what is to be done first in case of electrocution. 5 - Keep the phone number of the electricity company and of the nearest first aid station at hand. If the work equipment gets accidentally entangled in the cables, the operator must not leave the cab until the electricity company has insulated the line. When carrying out this kind of operations, ask everyone standing in the work area to keep away from the ma- chine and the work equipment and to respect the minimum safety distance prescribed.
Ask the electricity company in advance what are the voltage of the cables and the minimum safety distance. The minimum distances from overhead lines can vary in the different countries, according to the climate and to the percentage of humidity in the air. Indicatively, the distances indicated in the table below should be respected. 2.4.11 VISIBILITY Switch on the headlights or the work lights as soon as visibility decreases. If visibility decreases due to mist, smoke or heavy rain, stop the machine in a safe position and wait for the weather to improve until visibility becomes acceptable.
2.4.12 WORKING ON ICY OR SNOW-COVERED SURFACES If the ground is icy or covered with snow, the machine may not react with precision to the movements of the steering wheel. To reduce the risks connected with poor manoeuvrability, proceed as follows: 1 - travel using the accelerator smoothly and gradually; 2 - brake smoothly and only after slowing down, using the engine deceleration as much as possible; 3 - absolutely avoid any sudden braking, abrupt acceleration and sudden steering with short steering radius. When it has snowed heavily, the road shoulders and any obstacle are buried in the snow and are not visible, therefore proceed with care when clearing the snow.
50 DANGER Cable voltage Min. safety distance 1.0 kV (distribution line) 5 m 6.6 kV (2–3 insulators) 5.2 m 33 kV (min. 3 insulators) 5.5 m 66 kV (min. 6 insulators) 6 m 154 kV (min. 10 insulators) 8 m 275 kV (min. 19 insulators) 10 m RKA01680