Komatsu — 2.8.6 KEEPING THE MACHINE CLEAN

PRECAUTIONS TO BE TAKEN DURING MAINTENANCE 2.8.4 EQUIPMENT The normal or special equipment that must be installed on the machine or that have been removed must be stored in a safe place and positioned in such a way as to prevent them from fall- ing down. If they fall on someone, they can cause serious bodily harm. When assemblying or removing any equipment, make sure that the ropes and the lifting hook are in good conditions and proper- ly dimensioned for the load to be lifted. RKA00290 2.8.5 WORKING UNDER THE MACHINE Before performing service or repairs under the machine, always lower the work equipment to the ground or in any case lower it as much as possible.

If it is necessary to work under the boom when this is extended, even if partially, make sure to prevent it from accidentally lower- ing, using a suitable support stand. Always block the machine tyres. Do not work under the machine, if this is not sufficiently support- ed. RKA00280 2.8.6 KEEPING THE MACHINE CLEAN Spilled oil or grease, scattered tools or broken pieces are dan- gerous, because they may cause someone to slip or trip. Al- ways keep the machine and the work site clean and tidy. Before carrying out any cleaning operation, protect the areas where there are electric parts, in particular the engine central unit, identified by the apposite pictogram.

To clean the machine, use a pressurized jet of warm water or steam and the specific detergents available on the market. Do not use diesel oil, oil or solvents, since the former leave an oily coat that favours the sticking of dust, while the latter (even if weak) damage the painted surfaces and therefore facilitate rust- ing. RKA00300 While cleaning the machine, keep the pressurized jet at a mini- mum distance of approx. 60 cm, in order not to damage the warning plates and the pictograms. If any plate should be dam- aged, request Komatsu Utility or your Komatsu Utility Dealer to send you a new one and change it.

Water into the electric system provokes the oxidation of the contacts and may hinder the start of the machine or even make it start suddenly and abruptly. For this reason, avoid using water or steam jets to clean sensors, connectors or the inside of the operator's cab. 57