Komatsu — 3.2.5 MACHINE CONTROLS

INSTRUMENTS AND CONTROLS 4 - FRAME LEVELLING (optional) The levelling of the frame must be carried out only with the machine at rest, in TRAVEL-WORK operating mode and before lowering the stabilizers. Always level the machine frame before lifing the load to be handled. Avoid using the levelling control when the boom is lifted or extended, even if partially, with or without load. The frame must be levelled even when the machine travels on slopes that are transversal to the travel di- rection and even if the machine isn’t loaded.

The transversal levelling of the frame is achieved by pressing the rocker button (1) that, when released, stops the movement of the frame; the maximum inclination possible is ± 10°. 1 RKAA0591 The frame must be checked using the water level (2) (see «3.2.1 INSTRUMENTS»); the level must be centered laterally. If during travel the transversal gradient should exceed 2°, stop the machine and level the frame. 2 The frame levelling will be inhibited when boom inclination re- ferred to the frame exceeds approximately 30°. RKAA0531 95 DANGER