Komatsu — 3.2.5 MACHINE CONTROLS

INSTRUMENTS AND CONTROLS 5 - STABILIZERS CONTROL (optional) The stabilizers can be operated only in TRAVEL-WORK operating mode. Before lowering or raising the stabilizers, make sure that no person or obstacle is within their operating range. Before selecting a gear or the travel direction, make sure that the stabilizers have been completely raised. In case of operation with the front tyres touching the ground, consult the load chart corresponding to this condition. The stabilizers are lowered by pressing the push buttons (1) and (2), which control the right and left stabilizer, respectively, towards the front of the machine.

When the buttons are released the movement is interrupted and when the buttons are pressed in the opposite direction the stabi- lizers are raised. The stabilizers must be forced until the tyres are raised approx. 3- 5 cm from the ground, always paying attention to the levelling of the frame (for further details, see paragraph « 4 - FRAME LEVEL- LING (optional)»). The use of the stabilizers is inhibited when boom inclination re- ferred to the frame exceeds approximately 30°. 6 - BOOM CONTROL LEVER Before carrying out any manoeuvre with this lever, the operator must be seated in driving position, with fastened safety belt.

Before using the machine, the operator must get acquainted with the functions and use of all the con- trols grouped on the boom control lever. The lifting and extension of the boom must be carried out respecting the safety limits prescribed by the load chart corresponding to the configuration of the machine (with or without stabilizers and with the equipment installed), depending on the inclination and on how much the boom is extended. Information regarding safety is supplied by the warning lights and by the acoustic alarm of the SLI-Safe Load Indicator. For further details, see pos. « 7 - SLI-SAFE LOAD INDICATOR» and «3.3.1 READING THE LOAD CHARTS».

The boom control lever (1) is a multifunction lever, since it is equipped with other controls: boom extension and retraction po- tentiometer (2), solenoid valves (AUX1 - AUX2) for optional hy- draulic equipment and transmission declutch button (3). 2 AUX 1 1 3 AUX 2 RKAA0621 96 DANGER 1 2 RKAA0592 RKAA0592 DANGER