INSTRUMENTS AND CONTROLS 6-1 LEVER The boom control lever is positioned on the operator’s right and controls the boom lifting and lowering and the folding and dumping of the equipment according to the orthogonal movements listed below. N - Neutral A - Boom lowering B - Equipment dumping C - Boom lifting D - Equipment folding If the lever is operated following an inclined direction with re- spect to the machine axes, simultaneous movements, pro- portional to the inclination angle, are obtained, since the two hydraulic distributors responsible for the single functions are working at the same time.
A B N - Neutral A - Boom lowering – Equipment folding N D B - Boom lowering – Equipment dumping C C - Boom lifting – Equipment dumping D - Boom lifting – Equipment folding RKA01850 IMPORTANT In the TRAVEL–WORK operating mode, independently of the boom extension and in order to increase the transversal stability of the machine, if the boom inclination exceeds approximately 30° (which can be checked on the goniometer applied to the left side of the first section of the boom), the movement of the frame with respect to the axles is automatically locked (if the rear axle lock cylinder is installed). Normal conditions are automatically restored when the boom inclination is again below 30°.
6-2 BOOM EXTENSION-RETRACTION POTENTIOMETER This is a roller potentiometer (1) with proportional directional signals that automatically returns to the center when re- leased. When turned towards the front of the machine (A), it controls the extension of the boom; turned in the opposite direction (B), it controls the retraction of the boom. A A 1 B B RKAA0622 97