CLAAS ARGO K50, K60, K70 — SECTION 2 ELECTRICS

ELECTRICS 2.41 NOTE: New belts should be re-checked after the first 20 hours of use. Removal In the event that the alternator has to be removed from the vehicle, carry out the following steps: 1. Disconnect the battery. 2. Disconnect the alternator electrical connections. 3. Loosen the alternator pivot fasteners (1) and the alternator adjustment bar fastener (2). 4. Release the belt tension and remove the belt. 5. Remove the adjustment bar fastener (2) from the alternator and remove the pivot fasteners (1). (Make a note of the position of the washers and distance pieces to ensure correct reassembly). 6. Remove the alternator. Installation 1.

Place the alternator in position and assemble loosely the alternator pivot fasteners and adjustment bar fastener. (Ensure that the washers and distance pieces removed earlier are refitted correctly). 2. Fit the drive belt and move the alternator so that the drive belt tension is correct. (See Alternator Drive Belt Check). 3. Tighten the pivot and adjustment bar fasteners and recheck the drive belt tension. 4. Reconnect the alternator electrical connections. 5. Reconnect the battery.