CLAAS ARGO K50, K60, K70 — SECTION 2 ELECTRICS

2.42 ELECTRICS AUTOMATIC POWERSHIFT The Automatic powershift consists of an automatic powershift controller (1) located on the dashboard directly in front of the steering wheel and an FNR switch assembly (2) attached to the left hand side of the steering column. Automatic Powershift Controller Removal To remove the controller (1) carry out the following procedure: 1. Disconnect the vehicle battery. 2. Remove the two self tapping screws (3). 3. Carefully withdraw the controller (1) from the dashboard ensuring no strain is put on the electrical loom and the earth strap (5) (from Machines S/ No.51200472 only). 4.

Disconnect the electrical connector (4) and the earth strap (5) (from Machines S/No.51200472 only) from the rear of the controller and remove from the dashboard. Installation 1. Connect the electrical connector (4) and the earth strap (5) (from Machines S/No.51200472 only) to the rear of the controller (1). 2. Insert the controller into the dashboard. 3. Fit the two self-tapping screws (3) into the controller fascia and tighten. 4. Reconnect thre vehicle battery. 5. Carry out test of the Automatic powershift system using procedure the laid down in the Operator’s Manual.