SEN00282-01 10 Structure, function and maintenance standard Disc clutch Structure q The disc clutch consists of piston (2), plate (3), disc (4), pin (5), return spring (6) etc. to fix ring gear (1). When clutch is “disengaged“ (released) q As the oil from ECMV is cut off, piston (2) is pushed back rightward by return spring (6). q Inside teeth of disc (4) are engaged with out- side teeth of ring gear (1). q Plate (3) and disc (4) are released from the frictional force and ring gear (1), as the result, is also released. q Plate (3) is assembled to clutch housing (7) with pin (5).
Operation When clutch is “engaged“ (fixed) Oil passage in speed clutch q When the steering/directional/gear shift lever is set in the “neutral“ position, the 1st, 2nd, or 3rd speed is selected. q The oil from ECMV is sent with pressure to the rear side of piston (2) via the oil passage of housing (7) and pushes piston (2) leftward. q Piston (2) contacts plate (3) closely against disc (4) to stop rotation of disc (4) by use of the friction force generated between them. q The piston chamber of the clutch correspond- ing to the selected gear speed is filled with oil by electronically controlling the hydraulic circuit of each clutch.
q Since inside teeth of disc (4) are engaged with outside teeth of ring gear (1), ring gear (1) is locked. q When the steering/directional/gear shift lever is shifted from the “neutral“ position to the“for- ward“ or “reverse“ position, the pump is required to supply oil of quantity to fill the pis- ton chamber of the F clutch or R clutch. q When the gear speed is changed from “for- ward 1st“ to “forward 2nd“, the pump is required to supply oil of only quantity to fit the plate and disc of the 2nd clutch together since the F clutch has been filled with the oil. q The time lag in the gear shifting operation is reduced by controlling the oil in the clutch cir- cuit as explained above.
26 D65EX, PX, WX-15E0