Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FIELD DISASSEMBLY AND ASSEMBLY OF ONE LINK

SEN00950-00 50 Disassembly and assembly 3) Coat the press-fitting hole (a) for the pin in link (4) with gasket sealant (198-32- 19890). a If the link is used again, finish the press fitting hole for the pin smoothly with sandpaper. 3. Seal Install seal (8) with tool R6 . a Check that there is no oil on the contact surface of the link and seal. a Remove all oil and grease from portions (b). 4) Put tool R11 in contact with the end face of link (4), and press fit pin (1). a Press fit so that the side hole (b) in the pin is on the same side as the link tread. a Pin press fitting force: 147 – 196 kN {15 – 20 tons} a Always use a new pin. 4. Link sub-assembly 1) Install link sub-assembly (10).

a Check that there is no dirt or dust stuck to the surface of the seal or the end face on the bushing, then coat with oil (GO140B) using a clean cloth or small brush. 22 D65EX, PX, WX-15E0