Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FIELD DISASSEMBLY AND ASSEMBLY OF ONE LINK

50 Disassembly and assembly SEN00950-00 2) Install tool R12 (guide used when press fitting link) to bushing (7). 3) Install seal (8) with tool R6 . a Check that there is no oil on the con- tact surface of the link and seal. 5. Link 1) To determine the pushing pressure when carrying out the final assembly, measure the dimensions of the press-fitting hole for the pin in link (3) with a cylinder gauge, and note down the measurement. 4) Check that there is no dirt or dust stuck to the surface of the seal or the end face of the bushing, then coat with oil (GO140B) using a clean cloth or small brush. 5) Using tool R13 , press fit pin portion of link (3) to link sub-assembly (10).

a Pin press fitting force: 294 – 392 kN {30 – 40 tons} 2) Coat the press-fitting hole (a) for the pin in link (3) with gasket sealant (198-32-19890) . a If the link is used again, finish the press-fitting hole for the pin smoothly with sandpaper. 6) Using tool R14 , press fit bushing portion of link (3) to link sub-assembly (10). a To prevent the use of any excessive force, press fit the pin portion and bushing portion gradually in turn. D65EX, PX, WX-15E0 23