SEN00285-01 10 Structure, function and maintenance standard b. Operation of spring q The stop position for piston (9) [ = pump dis- charge amount] is decided at the point where for the force of springs (3) and (4), and the pushing force by solenoid and the pushing force created by pressure (PP) acting on pis- ton (2) are in balance. q The spring load of springs (3) and (4) in the TVC valve is determined by the swash plate position. q When servo piston (9) moves, cam (7) which is connected to rod (8), also moves. When this happens, lever (6) is rotated by the angle of cam (7), and piston (5) moves to the right and left.
q If piston (5) moves to the right, spring (3) is compressed, and if it moves further to the right, spring (4) contacts seat (10), so both springs (3) and (4) function. q The spring load is changed by piston (5) expanding or contracting springs (3) and (4). q If command current (X) input to solenoid (1) changes, the force pushing solenoid push pin (11) changes, and the spring load of springs (3) and (4) also changes according to the com- mand current (X) of the solenoid. q Port (c) of the TVC valve is connected to port (e) of the LS valve [see “1. LS valve“]. Self pressure (PP) enters port (b), the small piston diameter end of servo piston (9) and port (a).
q When pump pressure (PP) is small, piston (2) is on the right. q Port (c) and port (d) are connected, and the pressure entering the LS valve becomes drain pressure (PT). q If port (h) and port (e) of LS valve are con- nected [see “1. LS valve“], the pressure enter- ing the large piston diameter end from port (f) becomes drain pressure (PT), and servo piston (9) moves to the right. q The pump delivery will be set to the increasing trend. q As servo piston (9) moves further, piston (5) is moved to the left by rod (8), cam (7) and lever (6). Springs (3) and (4) expand and the spring force becomes smaller.
q When the spring force becomes smaller, piston (2) moves to the left, so the connection between port (c) and port (d) is cut, and port (c) is connected to port (b) of pump discharge pressure. q The pressure at port (c) rises, and the pressure at the large piston diameter end also rises, so the movement of piston (9) to the right is stopped. 24 D65EX, PX, WX-15E0