30 Testing and adjusting SEN00585-00 4) After finishing measurement, remove the measuring instrument and reinstall the removed parts. 3. Measuring torque converter outlet pressure 1) Remove oil pressure pickup plug (3) and attach nipple K3 , and connect hydraulic tester K1 . a Use an oil pressure gauge of 0.98 MPa {10 kg/cm 2 }. 2. Measuring torque converter inlet pressure 1) Remove oil pressure pickup plug (2) and attach nipple K3 , and connect oil pressure gauge [1] of hydraulic tester K1 . a Use an oil pressure gauge of 2.5 MPa {25 kg/cm 2 }. 2) Run the engine and set the PCCS lever in the full neutral position.
3) Measure the oil pressure while the engine is running at low idle and high idle. 2) Run the engine and set the PCCS lever in the full neutral position. 3) Measure the oil pressure while the engine is running at low idle and high idle. 4) After finishing measurement, remove the measuring instrument and reinstall the removed parts. 4) After finishing measurement, remove the measuring instrument and reinstall the removed parts. D65EX, PX, WX-15E0 35