30 Testing and adjusting SEN00585-00 1) Measuring transmission forward clutch pressure 1] Remove oil pressure pickup plug (6) and attach nipple K3 , and connect oil pressure gauge [1] of hydraulic tester K1 . a Use an oil pressure gauge of 5.9 MPa {60 kg/cm 2 }. 2] Run the engine and set the parking brake lever in free position. 3] With the brake pedal depressed, set the PCCS lever in the “forward” and 3rd gear speed position. 4] Measure the oil pressure while the engine is running at high idle. k Since the torque converter is stalled, keep pressing the brake pedal securely. k Do not run the engine at high idle while measuring.
5] After finishing measurement, remove the measuring instrument and rein- stall the removed parts. 4) Measuring transmission 2nd clutch pres- sure 1] Remove oil pressure pickup plug (8) and attach nipple K3 , and connect oil pressure gauge [1] of hydraulic tester K1 . a Use an oil pressure gauge of 5.9 MPa {60 kg/cm 2 }. 2] Run the engine and set the parking brake lever in free position. 3] With the brake pedal depressed, set the PCCS lever in the “forward” and 2nd gear speed position. 4] Measure the oil pressure while the engine is running at low idle. k Since the torque converter is stalled, keep pressing the brake pedal securely.
5] After finishing measurement, remove the measuring instrument and rein- stall the removed parts. 2) Measuring transmission reverse clutch pressure 1] Remove oil pressure pickup plug (6) and attach nipple K3 , and connect oil pressure gauge [1] of hydraulic tester K1 . a Use an oil pressure gauge of 5.9 MPa {60 kg/cm 2 }. 2] Run the engine and set the parking brake lever in free position. 3] With the brake pedal depressed, set the PCCS lever in the “forward” and 3rd gear speed position. 4] Measure the oil pressure while the engine is running at high idle. k Since the torque converter is stalled, keep pressing the brake pedal securely. k Do not run the engine at high idle while measuring.
5] After finishing measurement, remove the measuring instrument and rein- stall the removed parts. 5) Measuring transmission 3rd clutch pres- sure 1] Remove oil pressure pickup plug (9) and attach nipple K3 , and connect oil pressure gauge [1] of hydraulic tester K1 . a Use an oil pressure gauge of 5.9 MPa {60 kg/cm 2 }. 2] Run the engine and set the parking brake lever in free position. 3] With the brake pedal depressed, set the PCCS lever in the “forward” and 3rd gear speed position. 4] Measure the oil pressure while the engine is running at low idle. k Since the torque converter is stalled, keep pressing the brake pedal securely.
5] After finishing measurement, remove the measuring instrument and rein- stall the removed parts. 3) Measuring transmission 1st clutch pres- sure 1] Remove oil pressure pickup plug (7) and attach nipple K3 , and connect oil pressure gauge [1] of hydraulic tester K1 . a Use an oil pressure gauge of 5.9 MPa {60 kg/cm 2 }. 2] Run the engine and set the parking brake lever in free position. 3] With the brake pedal depressed, set the PCCS lever in the “forward” and 1st gear speed position. 4] Measure the oil pressure while the engine is running at low idle. k Since the torque converter is stalled, keep pressing the brake pedal securely. k Do not run the engine at high idle while measuring.
5] After finishing measurement, remove the measuring instrument and rein- stall the removed parts. D65EX, PX, WX-15E0 37