Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — ADJUSTING TRANSMISSION SPEED SENSOR (REPLACEMENT PROCEDURE)

SEN00585-00 30 Testing and adjusting Adjusting transmission speed sensor (replacement procedure) 1 2) Pull the connector of sensor (3) out of the flange hole of tube (6) and connect it to connector assembly (7). (securely until it clicks) 1. Remove the undercover of the fuel tank, then remove transmission speed sensor assembly (1) from steering case (2). 3) Install connector assembly (7) to tube (6). 3 Mounting bolt: 4.9 – 6.9 Nm {0.5 – 0.7 kgm} 4) Insert sensor (3) in the boss of tube (6) and secure it with nuts (4) and (5). a Installation dimension of sensor: Dimension measured at time of removal: (L) ± 0.2 mm 2. Measure installation dimension ( L ) of removed sensor (3).

a When replacing the sensor, be sure to measure dimension ( L ). 3 Locknut: 49 – 68.7 Nm {5 – 7 kgm} 2 Threads of sensor: Adhesive (LT-2) 4. Install sensor assembly (1) to steering case (2). q Standard clearance between bevel gear and sensor tip: 0.65 – 1.65 mm 5. After finishing adjustment, set the monitor panel in “Monitoring display mode” and check that it displays the transmission speed nor- mally. a For the operating method, see “Special functions of monitor panel (EMMS)”. a Monitoring code: 31400 (Transmission speed) 3. Assembly procedure for sensor assembly 1) Remove only nut (4) from sensor (3), and insert sensor (3) in the opening at the end of tube (6) from the connector side.

38 D65EX, PX, WX-15E0