SEN00585-00 30 Testing and adjusting Adjusting parking brake lever 1 1. Assembling and installing lever assembly 1) Assemble lever assembly (1) and adjust the operation of limit switch (2). a When assembling the lever assembly, disconnect the parking brake cable from the lever. 3. Checking brake oil pressure Check that the brake oil pressure is as follows when the parking brake lever is set in free and lock positions. a For the method of measuring the brake oil pressure, see “Measuring power train oil pressure”. q When lever is pulled up: OFF, low- ered: ON q Lock position: 0, Free position: Specified pressure q Operation stroke of limit switch: 3 mm 2) Install lever assembly (1). 2.
Adjusting installation length of parking brake cable 1) Connect parking brake cable (3) to the lever side and valve side, and adjust installation dimensions ( a ) and ( b ). 4. Checking limit switch Change the monitor panel to the monitoring display mode and set the parking brake lever in free and lock positions. Check that the limit switch signal is normal at this time. a For the operation method of the monitor- ing display mode, see “Special functions of monitor panel (EMMS)”. q Cable installation dimension ( a ): 148.5 mm q Cable installation dimension ( b ):
166 mm 2) Operate parking brake lever (4) between the free and lock positions, and adjust rod end (6) so that spool stroke ( h ) of brake valve (5) is normal. q Monitoring code: 40910 (Steering related controller switch input 1) q Spool stroke ( h ): 13.3 mm 42 D65EX, PX, WX-15E0