Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — TESTING AND ADJUSTING TRACK SHOE TENSION

30 Testing and adjusting SEN00585-00 Inspecting wear of sprocket 1 Testing and adjusting track shoe tension 1 a Use the “Full-scale dimensions drawing of sprocket profile” in the topic “Sprocket” in the chapter “Structure, function and maintenance standard” as a gauge for measuring wear of the sprocket. a Make a copy of the “Full-scale dimensions drawing of sprocket profile” on a transparent paper or sheet and apply it directly to the sprocket to see if the sprocket can be used. Testing 1. Drive the machine slowly on a level place, then stop it. a Do not apply the brake when stopping. 2.

Place straight steel bar between the idler and front carrier roller and measure clearance ( a ) between the bottom of the steel bar and shoe grouser. q Standard clearance ( a ): 20 – 30 mm Adjusting a If the track shoe tension is abnormal, adjust it according to the following procedure. 1. Remove cover (1). 2. When the tension is too high Loosen plug (2) to discharge the grease. k Since the high-pressure grease may spout out, do not loosen the plug more than 1 turn. 3 Plug: 59 – 88 Nm {6 – 9 kgm} 3. When tension is low Add grease through grease fitting (3). a If the track shoe is not tensed well, drive the machine forward and in reverse slowly. D65EX, PX, WX-15E0 47