Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — PREPARATION WORK FOR TROUBLESHOOTING FOR ELECTRIC SYSTEM

SEN00587-00 30 Testing and adjusting 4. KOMTRAX controller 1) Open cover (1) of the main control valve at the right side of the operator cab. 5. Air pressure sensor (AIR PRESSURE SEN- SOR) Engine Ne speed sensor (CRANK SENSOR) Engine Bkup sensor (CAM SENSOR) Engine oil pressure switch (OIL PRESSURE SWITCH) a Disconnecting and connecting connectors Since the connectors of air pressure sen- sor, engine Ne speed sensor, engine Bkup sensor and engine oil pressure switch have special lock mechanism, disconnect in the order of (a) – (c) and connect in the order of (d) – (f) as shown in the below fig- ure. Disconnect: (a) slide lever – (b) release lock – (c) disconnect con- nector Connect:

(d) connect connector – (e) mesh lock – (f) slide lever 2) Insert or connect T-adapters in or to G01 connector of KOMTRAX controller (2). 3) Connector K0M2, K0M3 are for communi- cation antenna. a Removal and installation of sensor When removing and installing engine oil pressure switch, use deep sockets with 27 mm width across flats and φ 22mm center hole diameter. 6 D65EX, PX, WX-15E0