40 Troubleshooting SEN00588-00 Classification and procedures of troubleshooting 1 Classification of troubleshooting Troubleshooting procedures When any symptom supposed to be a failure appeared on the machine, select a troubleshooting No. accord- ing to the procedures below and proceed to the text of the relevant troubleshooting: 1. Troubleshooting procedures when any action code is displayed on the monitor panel: When an action code is displayed on the monitor panel, display a failure code in the failure code display mode (electrical system, mechanical system) on the monitor display (EMMS).
Carry out the troubleshooting of the relevant [ failure code ] in accordance with the displayed failure code. a Since a failure code flashes when a failure is detected, the failure has not always been corrected even if it lights when the starting switch is set to ON. (For some codes, failures can be detected by only turning the starting switch ON.) a When a failure code has been recorded, be sure to perform the duplication operation corresponding to the failure code and confirm if the failure has still remained or has been already corrected. (For the duplication method, refer to the troubleshooting relevant to the failure code.) 2.
Troubleshooting procedures when a failure code has been recorded: When no action code is displayed on the monitor panel, display a failure code in the failure code display mode (electrical system, mechanical system) on the monitor display (EMMS). When a failure code has been recorded, carry out the troubleshooting of the relevant [ failure code ] in accordance with the displayed failure code. a Since a failure code flashes when a failure is detected, the failure has not always been corrected even if it lights when the starting switch is set to ON.
(For some codes, failures can be detected by only turning the starting switch ON.) a When a failure code has been recorded, be sure to perform the duplication operation corresponding to the failure code and confirm if the failure has still remained or has been already corrected. (For the duplication method, refer to the troubleshooting relevant to the failure code.) 3. Troubleshooting procedures when no action code is displayed and a failure code has not been recorded: When a failure code has not been recorded in the monitor panel (EMMS), a failure that the machine cannot diagnose by itself is supposed to have occurred in the electrical system or the hydraulic and mechanical system.
In this case, check again a symptom supposed to be a failure and select the relevant symptom out of the table of “Symptom supposed to be failure and troubleshooting No.” Then, carry out the trouble- shooting in the [ E-Mode ], [ H-Mode ] or [ S-Mode ] related to the symptom. D65EX, PX, WX-15E0 5 Mode Content Code display Troubleshooting by failure code E-mode Troubleshooting of electrical system H-mode Troubleshooting of hydraulic and mechanical system S-mode Troubleshooting of engine