Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [CA559] LOSS OF PRESSURE FEED FROM SUPPLY PUMP (1): LOSS OF PRESSURE FEED DETECTED

SEN00590-00 40 Troubleshooting Failure code [CA559] Loss of pressure feed from supply pump (1): Loss of pressure feed detected 1 42 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Loss of pressure feed from supply pump (1): Loss of pressure feed detected (Engine controller system) E02 CA559 Failure content • Loss of pressure feed (1) occurred in the common rail circuit. Controller's action • No particular action Symptoms that appears on machine • Engine does not start or engine is hard to start. • Exhaust gas color becomes black. • Engine output is reduced. General information • Common rail pressure can be checked with the monitoring function. (Code:

36400 Common rail pressure) • Duplication of failure code: Start the engine. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Fuel leakage to the outside Since the fuel leakage to the outside is suspected, check for a leak- age. (Visually check at low idle of the engine) 2 Defective low pressure cir- cuit device aRefer to Testing and adjusting “Fuel Pressure Inspection” for fuel low pressure circuit pressure inspection. • Measurement on the inlet side of the fuel filter • Cranking speed: Min. 150 rpm Fuel low pressure circuit pressure When cranking Min.

0.14 MPa {1.4 kg/cm2} • Measurement on the outlet side of the fuel filter Fuel low pressure circuit pressure At high idle Min. 0.48 MPa {4.9 kg/cm2} • Measurements on the inlet and outlet sides of the fuel filter • Fuel low pressure circuit pressure drop = fuel filter inlet pressure – fuel filter outlet pressure Fuel low pressure circuit pressure drop At high idle Min. 0.14 MPa {1.4 kg/cm2} aRefer to Testing and adjusting “Fuel Pressure Inspection” for fuel suction pressure inspection. • Measurement on the gear pump fuel inlet side of the supply pump Fuel suction circuit pressure (Gear pump side) At high idle Max. 33.9 kPa {Max.

254 mmHg} • Measurement on the fuel connector side Fuel suction circuit pressure (Fuel connector side) At high idle Max. 27.1 kPa {Max. 203 mmHg} 3 Defective injector (Including high-pressure pipes within the head) aAs for testing return amount of injector, see testing and adjusting “Testing fuel return and leak amount”. Injector return amount When cranking (When engine cannot start) Max. 100 cc/30 sec. At low idle (When engine can be started) Max. 300 cc/45 sec.