Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [CA2186] DECELERATOR PEDAL SENSOR POWER SOURCE TOO LOW: EXCESSIVELY LOW VOLTAGE DETECTED

40 Troubleshooting SEN00590-00 Failure code [CA2186] Decelerator pedal sensor power source too low: Excessively low voltage detected 1 Circuit diagram related to decelerator pedal D65EX, PX, WX-15E0 55 Action code Failure code Symptom of failure Decelerator pedal sensor power source too low: Excessively low voltage detected (Engine controller system) CALL E03 CA2186 Failure content • Excessively low voltage is detected at decelerator pedal sensor power source circuit. • Controller's action • Operates with the fixed value that is same as the value just before the abnormality is detected, if abnormality occurs with the starting switch in the ON position.

If the starting switch is turned to the ON position in the same abnormal condition, the controller oper- ates with 100% value. Symptoms that appears • on machine Engine speed cannot be controlled by decelerator pedal. General • information Duplication of failure code: turn ON the starting switch. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting Defective harness grounding 1 (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Between ground and wiring harness between CE02 (female) (22) – DCL (female) (A) Resis- tance Min.

100 kz Harness short 2 (Harness internal short) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Between CE02 (female) (9) – all pins of CE02 (female) (with DCL also disconnected) Resis- tance Min. 100 kz Defective wiring harness 3 connector Since the connections among decelerator pedal – body harness – engine controller are suspected to be defective, visually check them. • Connector is loose, lock is broken, seal is broken • Pin is corroded, bent, broken, pushed in, expanded.

• Moisture in connector, entry of dirt or sand, etc., and insufficient insulation 4 Defective engine controller Engine controller is possibly defective if no problem is found in causes 1 – 3. (Since this is an internal defect, it cannot be diag- nosed.)