SEN00594-00 40 Troubleshooting H-3 Machine does not move at any gear speed 1 6 D65EX, PX, WX-15E0 Symptom of failure • Machine does not move at any gear speed. General information • Check that the power train oil level is normal before troubleshooting. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective power train pump The power train pump is assumed to be defective; visually check it. 2 Defective set pressure or internal defect of transmis- sion main relief valve aPrepare with the starting switch OFF, and then run the engine at high idle for troubleshooting.
PCCS lever Transmission main relief pressure Full neutral Min. 3.04 MPa {Min. 31 kg/cm2} aPrepare with starting switch OFF and diagnose with starting switch still OFF. Visually check that the free length of spring and the number of shims are normal and also that the spool rotates smoothly. • Free length of large spring: 128 mm • Free length of small spring: 108 mm • Number of shims: 6 3 Defective operation of trans- mission valve (ECMV) aPrepare with the starting switch OFF, and then run the engine at low idle for troubleshooting. (Before this, check that the transmission main relief pressure is normal.) Transmission clutch Clutch pressure FWD Min. 2.84 MPa {Min. 29 kg/cm2} REV Min.
2.84 MPa {Min. 29 kg/cm2} 1ST Min. 2.84 MPa {Min. 29 kg/cm2} 2ND Min. 2.84 MPa {Min. 29 kg/cm2} 3RD Min. 2.84 MPa {Min. 29 kg/cm2} 4 Internally defective transmission The transmission clutch is assumed to be defective internally; visu- ally check it. 5 Defective brake valve aMove to a flat place, and run the engine at high idle for trouble- shooting. (Before this, check that the transmission main relief pressure is normal.) Brake pedal Brake oil pressure (left/right) Release Min. 2.55 MPa {Min. 26 kg/cm2} Depress 0 MPa {0 kg/cm2} When the oil pressure is abnormal, carry out troubleshooting “H-8 Brake does not work”.