Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — REMOVAL AND INSTALLATION OF CYLINDER HEAD ASSEMBLY

50 Disassembly and assembly SEN00945-00 3. Before tightening the cylinder head mounting bolts, check the following. 1) Measure stem length "a" of each mounting bolt and check that it is shorter than the using limit. 2) Using limit length of bolt: 162.6 mm a If a bolt is longer than the using limit, do not reuse it but replace it. 2 Apply engine oil (SAE15W-40) to the threads and seats of the mount- ing bolts. q Rocker housing assembly 5. Install push rod (98). a Check that the push rod is in the tappet. a Apply engine oil ( EO15W-40 ) to the push rod socket. 6. Fit the gasket and install rocker housing assembly (100). q Tighten the bolts in the order of [1] o [7] shown in the figure.

3 Mounting bolt: 24 ± 4 Nm {2.4 ± 0.4 kgm} 4. Tighten the mounting bolts by 2 – 3 turns with the fingers, and then tighten them according to the following procedure. 1) Tighten the cylinder head mounting bolts in the order shown below. 1] 150 ± 9.8 Nm {15.3 ± 1.0 kgm} 2] Return all bolts 360° 3] 115 ± 4.9 Nm {11.7 ± 0.5 kgm} 4] Check tightening torque of 115 ± 4.9 Nm {11.7 ± 0.5 kgm} 5] 120° ± 5° 7. Install spacer (99). q Tool A8 (See the Special tools table) is set for angle tightening. q When not using angle tightening tool A8 Make a mark on the cylinder head and each bolt with paint and then tighten the bolt by 120° ± 5° . D65EX, PX, WX-15E0 13