Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — REMOVAL AND INSTALLATION OF CYLINDER HEAD ASSEMBLY

SEN00945-00 50 Disassembly and assembly q Fuel injector assembly a Check that the fuel injector sleeve is free from flaws and dirt. 14. Tighten bolts (94) of holder (106) alternately. 3 Bolt: 9.8 ± 2.0 Nm {1.0 ± 0.2 kgm} a The top of holder (106) must be in parallel with the top of the cylinder head. Allowable angle: 2.4° 8. Fit gasket (104) and O-ring (105) to fuel injec- tor (97). 2 O-ring (105) of fuel injector (97) and cylin- der head side: Engine oil (EO15W-40) 15. Tighten inlet connector (96) permanently. 3 Nut: 40.2 ± 3.9 Nm {4.1 ± 0.4 kgm} 9. Install holder (106) to fuel injector (97). a Match the hollow and projection (B) and (A) to each other.

q Rocker arm and crosshead assembly a The shapes of holes "a" and "b" of each cross- head are different. Accordingly, when reusing the crossheads, install each of them to the same intake/exhaust valve in the same direc- tion as it has been installed. 10. Insert fuel injector (97) in the cylinder head, directing the fuel inlet hole toward the air intake manifold. 11. Tighten mounting bolt (94) of holder (106) 3 – 4 turns with the fingers. q A new crosshead may be installed in either direction. a Check that 2 valves are inserted in holes "a" and "b". 12. Fit O-ring (107) to inlet connector (96). 2 O-ring (107) of inlet connector (96) and cylinder head side: Engine oil (EO15W-40) 16.

Install rocker arm and crosshead assembly (93) and tighten mounting bolts (92) with the fingers. a Check that the ball of adjustment screw (91) is fitted in the push rod socket securely. a Check that the cap on the crosshead side of the rocker arm is in contact with a plane of the crosshead (that the cap is not in contact diagonally). a Apply engine oil to the threads and seat of the mounting bolt. 13. Install inlet connector (96) with nut (95) tempo- rarily. (Matching projection (C), push the inlet connector into the hole of the fuel injector.) 3 Nut: 14.7 ± 5.0 Nm {1.5 ± 0.5 kgm} 17. Tighten mounting bolt (92). 3 Bolt: 64.7 ± 4.9 Nm {6.6 ± 0.5 kgm} a Adjust the valve clearance.

For details, see Testing and adjusting, “Testing and adjusting valve clearance”. 3 Locknut (90): 24 ± 4 Nm {2.45 ± 0.41 kgm} 14 D65EX, PX, WX-15E0