50 Disassembly and assembly SEN00945-00 18. Install wiring harness (89). a Install wiring harness (89) so that it will not touch the inside wall of rocker housing assembly (100) strongly or come off guide (g) or bend sharply. Reference If the MIKALOR clamp was removed, install new one carefully according to the following procedure. a Use a new MIKALOR clamp. a Set the hose to the original (marked) position. (Insertion depth of air hose: 60 mm) a Set the bridge (BR) so that its clamp bolt will be at the bottom and it will be lapped over band (BD) by at least min. 5 mm. 3 Mounting nut: 1.25 ± 0.25 Nm {0.10 ± 0.03 kgm} a Installed position of wiring harness 2 Threads of clamp bolt:
Lubricating oil: THREEBOND, PAND18B a Do not use an impact wrench. q When reusing the hose a Set the clamp to its original position. 3 MIKALOR clamp: Min. 6 Nm (1.6 kgm} q When using a new hose a Tighten until band gap (BDG) is 17 – 20 mm . [*2] 3 Air hose clamp: 10.5 ± 0.5 Nm {1.07 ± 0.05 kgm} [*3] 3 Air cleaner band: 9.8 – 11.8 Nm {1 – 1.2 kgm} [*4] 3 Fuel tube joint bolt: 24 ± 4 Nm {2.45 ± 0.41 kgm} q Carry out the following installation in the reverse order to removal. [*5] [*1] q Fuel hose (20) k The internal parts of the adapter may be damaged when fuel tube (20) is removed. Accordingly, replace the adapter with new one. q Turbocharger side 3 Clamp:
7 ± 1.1 Nm {0.71 ± 0.11 kgm} q Air aftercooler side 3 Air hose clamp: 10.5 ± 0.5 Nm {1.07 ± 0.05 kgm} D65EX, PX, WX-15E0 15 Color of wiring harness Cylinder No. Yellow, Orange (Exchangeable) 1, 3, 5 Red, Brown (Exchangeable) 2, 4, 6