Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — DISASSEMBLY AND ASSEMBLY OF TRQFLOW TRANSMISSION ASSEMBLY

50 Disassembly and assembly SEN00947-00 2) Remove spacer (47) from No. 2 carrier assembly (45). 3) Remove No. 2 ring gear (48). 4) Pull out shaft (49) and remove thrust washer (50), gear (51), bearing (52), and ball (53). a Take care not to lose ball (53). 15. No. 3 ring gear Remove No. 3 ring gear (60). 16. No. 3 and No. 4 carriers and output shaft assembly Using eyebolts [7], remove No. 3 and No. 4 carriers and output shaft assembly (61). 5) Remove snap ring (54). 6) Remove snap ring (55) and ring gear (56). a Contract snap ring (55) by inserting round rods [6] with a diameter of less than 3 mm in 2 diagonal holes of 4 on the ring gear and pull out ring gear (56). 17. Disassembly of No.

3 and No. 4 carriers and output shaft assembly 1) Remove snap ring (62), then remove out- put shaft assembly (63) from No. 3 and No. 4 carriers (64) with push tool [8]. 2) Remove seal ring (65). 3) Drive pin (66) into shaft (67). 4) Drive out shaft (67) from No. 3 carrier side. 14. No. 3 discs, plates, and springs 1) Remove 5 No. 3 springs (57). 2) Remove 4 No. 3 discs (58) and 3 plates (59). D65EX, PX, WX-15E0 23