TIC LEXION Montana 570-520 Electric System Description of function: 1/5 Axle control system and front attachment control system The system identifies the machine position using the inclination sensors B126-1 / B126-2 which transmit their values to the Montana module (A35) via an internal CAN bus. The solenoid coils (Y114, Y115, Y116, Y117) are actuated by the Montana module (A35) so that the machine is always in a vertical position by means of front axle movements.
If the control system speed is not sufficient, the Montana module (A35) additionally actuates an oil quantity increase solenoid coil (Y118) in connection with the working hydraulics master valve (Y77) via the gear pre-selection module (A36) - circuit diagram 4s. The position of the front attachment is adapted by rotating the front attachment frame (Y112, Y113) and by changing the cutting angle (Y110, Y111). This front attachment control system works independently of the AUTOCONTOUR system. The Montana module (A35) receives the necessary feedback about the current position of the corresponding function from the respective angle sensors (B91, B92, B93, B94, B95). Important!
All system calibrations using the Montana terminal (A41) require that the Montana control unit module A35 receives the signal from the unactuated parking brake (S93) - Circuit diagram 42s. Axle control system diagnosis via Montana terminal A41 Call up the diagnosis menu with the menu key, the yellow cutting angle increase / decrease keys and the Enter key. - Diagnosis inputs Select the inputs section using the yellow keys and the Enter key. Diagnose Inputs Inclinometer Outputs System 03/05 Lex-e-41s 41s-3