Komatsu — Dynamic Retard Pedal

OM3242 Operator Cab And Controls - Section 32 Page 32-3 PEDALS Dynamic Retard Pedal Dynamic retard pedal (3, Figure 32-1) is a foot oper- ated pedal which allows the operator to slow the truck and maintain a safe productive speed without the use of the service brakes. For normal truck oper- ation, only dynamic retarding must be used to slow and control the speed of the truck. The Grade/Speed Chart (8, Figure 32-1) must always be followed to de- termine MAXIMUM safe truck speeds for descending various grades with a loaded truck.

Service brakes must be applied only when dynamic retarding re- quires additional braking force to slow the truck speed quickly or to bring the truck to a complete stop. Service Brake Pedal The service brake pedal (2, Figure 32-1) is a foot operated pedal which applies the service brakes. Service brakes must only be applied when dynamic retarding requires additional braking force to slow the truck speed quickly. They must also be used to bring the truck to a complete stop once the speed is less than 4.8 kph (3 mph).

Dynamic Retarding Dynamic retarding is a braking torque (not a brake) produced through electrical generation by the wheel- motors when the truck motion (momentum) is the propelling force. When dynamic retarding is in operation, the engine rpm will automatically go to an advance rpm retard speed setting (usually 1250 rpm)*. Dynamic retarding will be applied automatically, if the speed of the truck reaches the predetermined overspeed retard setting. Dynamic Retarding is available in FORWARD/ REVERSE at all truck speeds above 0 kph/mph, but is available in NEUTRAL only when truck speed is above 4.8 kph (3 mph).

For normal truck operation, dynamic retarding must be used to slow and control truck speed. Dynamic retarding is available in FORWARD/ REVERSE at all truck speeds above 0 kph/mph; however, as the truck speed slows below 4.8 kph (3 mph), the available retarding force may not be effec- tive. Use the service brakes to bring the truck to a complete stop. Dynamic retarding will not hold a stationary truck on an incline.Use the parking brake or wheel brake lock for this purpose. Dynamic retarding is available in NEUTRAL only when truck speed is above 4.8 kph (3 mph). When dynamic retarding is in operation, engine rpm will automatically go to an advance retard speed set- ting.

This rpm will vary depending on temperature of several electrical system components. Dynamic retarding will be applied automatically if the speed of the truck obtains the maximum speed set- ting programmed in the control system software. When dynamic retarding is activated, an indicator light in the overhead display will illuminate. The grade/speed retard chart must always be used to determine safe downhill speeds. Refer to Grade/ Speed Retard Chart in this chapter.