OM3242 Operator Cab And Controls - Section 32 Page 32-5 The "short term" numbers listed on the chart indicate the combination of speeds and grades which the vehicle can safely negotiate for a short duration before system components reach the maximum allowable temperature during retarding. These speeds are faster than the "continuous" values, reflecting the thermal capacity of various system components. System components can accept heat- ing at a higher-than-continuous rate for a short period of time. Beyond this short duration of time, the sys- tem would become overheated. The "short term" rating will successfully accommo- date most downhill loaded hauls.
It is necessary to divide haul road grade segment length by allowable speed to determine actual time on grade. If actual time on the grade exceeds the allowable limits, the grade will need to be negotiated at the "continuous" speed. The "continuous" numbers on the chart indicate the combination of speeds and grades which the vehicle can safely negotiate for unlimited time or distance during retarding. If the vehicle is operated at "short term" grade and speed limits for a period of time exceeding thermal capacity, the Propulsion System Controller (PSC) gradually reduces retarding effort from "short term" to "continuous".
The "retard @ continuous" indicator light will illuminate alerting the operator of the retard- ing reduction and the need for a reduction in speed. The operator must use the service brakes to quickly slow the truck to maximum "continuous" retarding limits or less. DO NOT exceed these recommended MAXIMUM speeds when descending grades with a loaded truck. DO NOT LIGHTLY apply the service brakes when attempting to slow the truck on a downhill grade. Overheating of the brakes will result. FULLY apply the brakes (within safe limits for road con- ditions) in order to quickly slow the truck to max- imum "continuous" retarding limits or less. NOTE:
The "three minute" curve is a MINIMUM; the actual time limit could be greater. Ambient temperature, barometric pressure and recent motor power levels can affect this number.