Komatsu — Directional Control Lever

OM3242 Operator Cab And Controls - Section 32 Page 32-7 CENTER CONSOLE Directional Control Lever Directional Control Lever (2, Figure 32-3) is mounted on a console to the right of the operator's seat. It is a four position lever that controls the park, reverse, neutral, and forward motion of the truck. Before mov- ing the directional control lever, apply the service brakes to completely stop the truck. Depress the but- ton on the side to release the detent lock, then move the control lever to the desired position. When the control lever is in the center N position, it is in NEU- TRAL. When the control lever is in the P position, it is in PARK, and the parking brake will be applied.

The parking brake is spring applied and hydraulically released. It is designed to hold the truck stationary when the engine is off and the key switch is turned OFF. The truck must be completely stopped before moving the control lever to PARK, or damage may occur to the park brake. When the key switch is ON, and the control lever is in PARK, the parking brake indicator light (A3, overhead panel, Figure 32-8) will be illuminated. FIGURE 32-3. CENTER CONSOLE 1. Center Console 2. Directional Control Lever 3. Override/Fault Reset Switch 4. Engine Stop Switch 5. L.H. Window Control Switch 6. R.H. Window Control Switch 7. Hoist Control Lever 8. Retarder Speed Control Dial 9. RSC Switch 10.

Data Store Button 11. VHMS Snapshot In Progress Light 12. Link Energized Light (Red) 13. Service Engine Light (Blue) 14. 12V Auxiliary Power Outlets The directional control lever must be in PARK to start the engine. NOTE: DO NOT move the directional control lever to the PARK position at the shovel or dump. The operator can select FORWARD drive by moving the control lever to the F position. The operator can select REVERSE drive by moving the control lever to the R position. DO NOT allow the control lever to travel too far and go into the PARK position when REVERSE is desired. NOTE: The truck must be completely stopped before the control lever is moved to a drive position or into PARK.

A GE fault will be recorded if the control lever is placed into the PARK position while the truck is still moving.