Komatsu — Lowering The Dump Body

Operator Cab And Controls - Section 32 OM3242 Page 32-8 Override/Fault Reset Switch Switch (3, Figure 32-3) is spring-loaded to the OFF position. When pushed in and held, this switch may be used for several functions. R.H. Window Control Switch Switch (6, Figure 32-3) is spring-loaded to the OFF position. Pushing the front of the switch raises the right side cab window. Pushing the rear of the switch lowers the window. 1. This switch permits the operator to override the body-up limit switch and move the truck forward when the directional control lever is in FOR- WARD, the dump body is raised, and the brakes are released.

Hoist Control Lever Hoist control (7, Figure 32-3) is a four position hand- operated lever located between the operator seat and the center console (see illustration below). Use of the override switch for this purpose is intended for emergency situations only! 2. The push button deactivates the retard pedal function when speed of truck is below 4.8 kph (3 mph). 3. The override switch is also used to reset an electric system fault when indicated by a red warning light. Refer to Overhead Status/Warn- ing Indicators in this section. Engine Stop Switch Switch (4, Figure 32-3) is used to stop the engine. Pull the switch up to stop the engine. Push the switch back down to enable engine operation.

Raising The Dump Body 1. Pull the lever to the rear to actuate hoist circuit. (Releasing the lever anywhere during "hoist up" will place the body in HOLD at that position.) Use this switch to stop the engine if the key switch fails to operate, or to stop the engine without turning off the 24 VDC electrical circuits. 2. Raise engine rpm to increase hoist speed. A ground level engine stop switch is also located at the right front corner of the truck. 3. Reduce engine rpm as the last stage of the hoist cylinders begin to extend and then let the engine go to low idle as the last stage reaches half-extension. L.H. Window Control Switch 4.

Release hoist lever as the last stage reaches full extension. Switch (5, Figure 32-3) is spring-loaded to the OFF position. 5. After material being dumped clears the body, lower the body to frame. Pushing the front of the switch raises the left side cab window. Refer to Operating Instructions - Dumping, for more complete details concerning this control Pushing the rear of the switch lowers the window. Lowering The Dump Body Move hoist lever forward to DOWN position and release. Releasing the lever places hoist control valve in the FLOAT position allowing the body to return to frame.