OM3242 Operator Cab And Controls - Section 32 Page 32-9 Dial (8, Figure 32-3) allows the operator to vary the downhill truck speed that the retard speed control system will maintain when descending a grade. This function can be overridden by either the accelerator, retard lever, or retard pedal. Retard Speed Control (RSC) Adjust Dial With RSC switch on and dial adjusted, the system will function as follows: As truck speed increases to the "set" speed and throttle pedal released, dynamic retarding will apply. As truck speed tries to increase, the amount of retarding effort will automatically adjust to keep the selected speed.
When truck speed decreases, the retarding effort is reduced to maintain the selected speed. If truck speed continues to decrease to approximately 4.8 kph (3 mph) below "set" speed, dynamic retarding will turn off automati- cally. If truck speed must be reduced further, the operator can turn the adjust dial to a new setting or depress the foot operated retard pedal. When the dial is rotated counterclockwise toward this symbol, the truck will descend a grade at lower speeds. When the dial is rotated clockwise toward this symbol, the truck speed will increase. Always refer to the Grade/Speed Retard Chart in the operator's cab and follow the recommendations for truck operation.
DO NOT exceed these recom- mended MAXIMUM speeds when descending grades with a loaded truck. If the operator depresses the foot operated retard pedal and the retard effort called for is greater than that from the automatic system, the foot pedal retard will override RSC. Throttle pedal position will override RSC setting. If operator depresses throttle pedal to increase truck speed, dynamic retarding will not come on unless truck overspeed setting is reached or foot operated retard pedal is used. When throttle pedal is released and RSC switch is on, dynamic retarding will come on at, or above, the RSC dialed speed and will adjust truck speed to, and maintain, the dialed speed.
Retard Speed Control (RSC) Switch Switch (9, Figure 32-3) turns the system on and off. Push the knob in for OFF and pull the knob out to turn the system ON. To adjust RSC control, pull switch (9) ON and start with dial (8) rotated toward fastest speed while driv- ing truck at desired maximum speed. Relax throttle pedal to let truck coast and turn RSC adjusting dial slowly counterclockwise until dynamic retarding is activated. Dynamic retarding will now be activated automatically anytime the "set" speed is reached, the RSC switch is on, and throttle pedal is released.