Operator Cab And Controls - Section 32 OM3242 Page 32-10 Button (10, Figure 32-3) is for use by qualified main- tenance personnel to record in memory a “snap-shot” of the AC drive system. It will also trigger the VHMS system to store a snap-shot of the truck operating system. Light (11, Figure 32-3) will stay illuminated while the VHMS system is recording the snap-shot. Data Store Button Truck Control Interface (TCI) Diagnostic Port Diagnostic port (4) is used to access diagnostic infor- mation for the Truck Control Interface (TCI). Propulsion System Controller (PSC) Diagnostic Port Diagnostic port (4) is used to access diagnostic infor- mation for the Propulsion System Controller (PSC).
VHMS Snapshot In Progress Light Light (11, Figure 32-3) is an indicator that will illumi- nate while the VHMS system is in the process of tak- ing a snapshot of machine data. Engine Diagnostic Port (CENSE) Diagnostic port (6) is a three pin connector used to access diagnostic information for the engine monitor- ing system. Link Energized Light Light (12, Figure 32-3) is a red indicator that, when illuminated, indicates that the AC drive system is energized. No one is permitted to work on the AC drive system while this light is illuminated. Engine Diagnostic Port (QUANTUM) Diagnostic port (7) is a nine pin connector used to access diagnostic information for the engine control system.
Service Engine Light Light (13, Figure 32-3) is a blue indicator that will illu- minate if a problem is detected by the electronic engine monitoring system. Electric propulsion and dynamic retarding will still be available. If this light is ON, notify maintenance personnel so they can diagnose and repair the problem the next time the truck is in the shop for repairs or at the next PM (Preventive Maintenance) interval. DIAGNOSTIC PORTS The diagnostic ports shown in Figure 32-4 are located on the back wall of the cab next to the D.I.D. Panel. FIGURE 32-4. DIAGNOSTIC PORTS 1. VHMS Diagnostic Port 2. IM Diagnostic Port 3. Payload Meter Diagnostic Port 4. TCI Diagnostic Port 5.
PSC Diagnostic Port 6. Engine Diagnostic Port (CENSE) 7. Engine Diagnostic Port (QUANTUM) VHMS Diagnostic Port Diagnostic port (1, Figure 32-4) is used to download truck operation data from the VHMS controller. Interface Module (IM) Diagnostic Port Diagnostic port (2) is used to connect the interface module to a computer for installing software. Diagnostic port (3) is used to download data from the payload meter system. Refer to Section 60, Payload Meter III, for a more complete description of the pay- load meter and its functions. Payload Meter Diagnostic Port