PACCAR Corporation — Parameter Part Numbers

7 Multiplexed Electrical System Service Manual 7 - 10 PM819023/KM815057 (08/14/2012) CECU Parameter Part Number Parameter Description Min. Value Max. Value Explanation Q30-1024-086 Fleet ID Available 0 1 Parameter controls whether the Fleet ID is visible in the Truck Information screen in the MFD. Value 0/Disabled means the Fleet ID is not visible in the Truck Information screen. Value 1/Enable means the Fleet ID is enabled in the Truck Information screen. This requires the Fleet ID to be programmed by ESA, otherwise it will not be visible. Q30-1024-088 Diesel Exhaust Fluid Gauge Installed 0 1 Parameter controls fault logging and gauge needle if the DEF gauge is installed.

Value 0/Disabled means that no faults will be logged and the gauge needle will not move if the gauge is installed. Value 1/Enable means that DTCs will be logged if the DEF information from the aftertreatment system is not available and the gauge needle will respond to DEF level changes. Q30-1024-089 DRL Enabled 0 1 Parameter controls the DRL functionality of the exterior lighting. Value 0/Disable means the headlamp switch and high beam switch control the headlamps. When they are turned off, the headlamps will turn off. Value 1/Enabled means the low beams (at 50% power) or integrated turn signal will be on at all times when the headlamp or highbeam switch is not on.

Q30-1024-090 DRL Inhibit Switch Type 0 2 Parameter controls the behavior of the DRL Inhibit Switch. Value 0/None means that the DRL Inhibit Input is not observed by the CECU. Value 1=Normal means that the DRL will be disabled when the switch is active. Value 2=Canadian (10 sec max) means that the DRL will be disabled when the switch is active, for a maximum of 10 seconds. After 10 seconds, the DRL will turn back on and a DTC will be active as long as the DRL switch is still active. Q30-1024-092 Fog Lamps Installed 0 1 Parameter controls the fog lamp outputs of the Chassis Node. Value 0/Disabled means the fog lamp output is not driven. If fog lamps are installed, they will never be lit.

Value 1/Enabled means the fog lamp output will output faults (open, short). Q30-1024-093 Lights With Wipers Enable 0 1 Parameter controls whether the menu item is available for Lights with Wipers. When enabled by the operator through the MFD, the low beam headlamps will turn on whenever the wipers are active (INT, LOW, or HI). Value 0/Disabled means the headlamps will not turn on when the wipers are active. Value 1/Enabled means the headlamps will turn on when the wipers are active.